See all forum discussions about CS-2009 MRc6

Subscribe to new posts about CS-2009 MRc6 Post a new question aboutCS-2009 MRc6

See LEEDuser’s guidance on CS-2009 MRc6»

FAQs about MRc6 :

We are pursuing IEQc4.5 from LEED-CI as an ID credit. Are we then required to include the cost of furniture in MRc3–7?

What building components are typically purchased with FSC content to earn this credit?

We’re having trouble getting FSC wood within our budget. Can we use products with another forestry certification?

Do I need to provide invoices for all of the new wood products purchased for the project, or just FSC wood products?

I have supporting manufacturer documentation for the FSC wood used on our project. Is this enough to document this credit, or do I need invoices as well?

Can products labeled “FSC Recycled” or “FSC Recycled Credit” contribute towards MRc7? What about "FSC Mix" percentages that refer to recycled content?

Does FSC-certified wood automatically contribute to IEQc4.4 as a low-emitting material?

We are using a lot of reclaimed wood. Should we include this in our MRc7 calculations? What about wood that is already installed on the project, in a renovation? What about wood products with recycled content?

Does FSC-certified bamboo products count towards this credit?

A product has FSC-certified veneer, but a non-certified core. Can we prorate the MRc7 contribution of this product based on the cost of the veneer?

Should wood used on site features such as benches or a gazebo be included here?

Is there a minimum quantity of wood that must be used on the project to qualify for this credit?

View answers »

Forum discussion

CS-2009 MRc6:Certified Wood

Certified Wood & Hardware

Bryan Finnegan

LEEDuser Basic Member

1 thumbs up

Project location :

December 30, 2015

Our invoices do not break out any hardware used with the millwork as a separate line item. Is it required to exclude these values for Certified Wood?

Post a reply

Megan White

Chief Sustainability Officer

Integral Group

LEEDuser Basic Member

11 thumbs up

Wed, 12/30/2015 - 19:49

Hi Bryan, Yes you need to break the hardware out from the millwork order. Certified Wood credits are looking at cost of wood only for comparison. I would recommend that you go back to the manufacturer with this request.

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.