See all forum discussions about CI-2009 SSc2
 Subscribe to new posts about CI-2009 SSc2 Post a new question aboutCI-2009 SSc2
See LEEDuser’s guidance on CI-2009 SSc2»
FAQs about SSc2 :

Is my site previously developed?

What exactly does LEED mean by residential neighborhood or area?

Only a portion of my complying residential development lies within the ½-mile radius. Will this suffice for credit compliance?

Where do I draw the radius from?

Is one building or residential area enough to satisfy the residential density requirement?

My project has access to services that seem to be basic, but are not listed in the LEED Reference Guide—like insurance company, nail salon, auto repair shop. Will these count?

My project is on a base or campus where some services are available to the population of the project, but not the general public. Do these count?

For Option 2, does the residential neighborhood with average density of 10 units per net acre have to be existing, or can planned neighborhoods count towards earning this option?

What site area should be used for an interiors project when figuring out the density radius? The building site area, or building footprint?

View answers »

Forum discussion

CI-2009 SSc2:Development Density and Community Connectivity

Building under Construction

Also for Option 1 / Density, our project has two buildings under construction (independent, not related to ours). They are well under way but not complete. Could we count them?

0
Post a reply

You rely on LEEDuser. Can we rely on you?

LEEDuser is supported by our premium members, not by advertisers.

Go premium for $15.95  »

Sun, 12/06/2015 - 23:19

Eric, Again, I personally have not documented this credit before and am not certain. But take a look at LI #3131 and 6012. It looks like it is acceptable to take into consideration future planned developments. In your case, the buildings are underway, so I’d imagine they can be counted. Note that these are for LEED NC v2, but I think the same logic applies here too. Hope that helps a little.

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.