See all forum discussions about NC-v4 EQc2
 Subscribe to new posts about NC-v4 EQc2 Post a new question aboutNC-v4 EQc2
See LEEDuser’s guidance on NC-v4 EQc2»
FAQs about EQc2 :

Is all solid wood considered inherently non-emitting? I’ve seen sources that say only solid wood flooring counts as inherently non-emitting.

Our building is atypical, and the walls and ceilings are not clearly defined. How should we classify these components? 

Are throw rugs subject to the credit requirements?

If a ceramic tile receives a top coat after it is manufactured, is it exempt from the credit requirements?

What are the adhesives and sealants to be included in the documentation?

I'm looking for a certification that tells me if a given product will meet the LEED v4 requirements, but I don't see one in a given product area. Am I missing something?

When products claim that they meet California Section 01350, does the product also meet LEED v4 requirements for low-emitting materials?

How do I know if a product complies with LEED v4 or if it was tested under an older non-compliant standard?

In past versions of LEED, it was easy to specify VOC limits. Is the specification process the same for LEED v4?

Is there a VOC budget method for this credit?

What are the limits on the VOC budget method?

Do products applied to the weather barrier need to comply with VOC thresholds? 

If one part of my multicomponent wall system is not compliant, can I still get full credit?

View answers »

Forum discussion

NC-v4 EQc2:Low emitting materials

Low Emitting Materials Calculator and Precast Wall Panels

In regards to the low emitting materials calculator (v4.1) what is the proper way to document insulated and non-insulated precast concrete wall panels. 

 

 

 

0
Post a reply

You rely on LEEDuser. Can we rely on you?

LEEDuser is supported by our premium members, not by advertisers.

Go premium for $15.95  »

Default Avatar
Jack Statham
Lean & Sustainability Specialist
Chandos
LEEDuser Basic Member
3 thumbs up

Fri, 08/12/2022 - 15:59

Not sure if it is the best way - But I have not had it returned. I break the Precast into it's individual components then provide the back-up for each individual material as applicable (Etc. Ready mix concrete, reinforcing, and insulation). I also do this for acoustic panels because I find it hard to get system compliance documentation but the fabric, adhesive, backing, and insulation typically have material specific compliance. 

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.