Our question pertains to is a mixed use residential - commercial highrise; 15 stories, 159,646 GSF total; 147,364 GSF housing, 46,994 GSF parking below grade; 4,204 GSF retail at the ground floor. Our M&V plan was developed in accordance with the IPMVP Option D. Energy savings calculations are to be validated by calibrating the original energy simulation model developed for projecting savings during design of the project. This calibration will be accomplished by using information from the following sources: Permanently installed metering: monthly gas and electric utility billing data and key submetered gas and electric end-uses. This will enable accounting of domestic hot water energy, heating energy, cooling energy consumption, and on-site energy production. Baseline measurements on public area electrical lighting loads that will be effected by lighting control strategies to verify baseline energy loads. Periodic temporary metering: periodic metering using data loggers to confirm actual electrical energy consumption by lighting in public areas effected by lighting control strategies. Sampling of residential lighting using a strategy based on the California HERS sampling strategy. In the preparation of the M&V plan we have concentrated our effort on the specification of sufficient data to provide adequate tools for the future verification energy modeler. The engineering calculations, operational estimates, utility meter-billing analysis, statistical sampling methods, metering and monitoring techniques outlined in this plan are commonly used sources of information used to perform the analysis prescribed by the Option D protocol, demonstrating compliance with the credit requirements. Please confirm that the plan as described plan satisfies the intent of EAc5. Thank you.