See all forum discussions about NC-2009 EAp2

Subscribe to new posts about NC-2009 EAp2 Post a new question aboutNC-2009 EAp2

See LEEDuser’s guidance on NC-2009 EAp2»

FAQs about EAp2 :

The project is built on a site with existing exterior lighting installed. How should this be accounted for?

Can mezzanines open to floors below be excluded from the energy model?

How do I provide a zip code for an international location?

For a project outside the U.S., how do I determine the climate zone?

For a project outside the U.S., how do I determine the Target Finder score?

Do hotel rooms need automatic light shut-off control?

How commonly are the 90.1 mandatory compliance forms submitted as part of EAp2/EAc1?

The Section 9 space-by-space method does not include residential space types. What should I use?

Can the Passive House Planning Package (PHPP) be used to energy model for LEED?

Is it acceptable to model a split-type AC with inverter technology compressor as a heat pump, like modeling VRF?

Can the Trace 700 'LEED Energy Performance Summary Report' by uploaded to LEED Online in lieu of the Section 1.4 tables spreadsheet?

A portion of our building envelope is historic. Can we exclude it from our model?

Which baseline HVAC system do I use if my building has no heating or air conditioning?

For an existing building, do I need to rotate the model?

Our project has a diesel backup generator. Should we include it in our energy model?

Our project has a large process load—75%. Despite our efforts to make an efficient HVAC design, the cost savings are minimal. What can we do to earn this prerequisite and be eligible for LEED certification? Is there any flexibility in how we model the p

Can SHGC be higher in the proposed than in the baseline model?

Our process load is higher than 25%. Do we have to justify that?

Do I need to justify the electrical and fuel rates I am using in my model?

Our local code references ASHRAE 90.1-2010. Should I use that for my documentation, or 90.1-2007?

View answers »

Forum discussion

NC-2009 EAp2:Minimum Energy Performance

Baseline existing building envelopes

FABIO VIERO

Head of Sustainability

Manens S.p.A.

LEEDuser Premium Member

16 thumbs up

Project location :

January 14, 2016

Hi, We are currently working on an existing building under major renovation, pursing a LEED certification following NC protocol v.2009. We have a doubt in relation to the table G.3.1.5.f requirements, regarding the reference thermal transmittance values of opaque elements and fenestration used for the existing baseline-building envelope construction: Can the baseline model consider the above-mentioned performance values taken from a reference table issued by the National Energy Agency, reporting reference values and construction assemblies classified per age range and building use? Thanks.

Post a reply

Marcus Sheffer

LEED Fellow

7group / Energy Opportunities

LEEDuser Expert

4454 thumbs up

Thu, 01/14/2016 - 15:35

Ciao Fabio! I don't think so but you might be able to make that case depending on the details. Hard to say for sure without knowing more about the situation. You really should determine the actual composition of the existing walls and calculate the assembly U-value accounting for the structure.

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.