See all forum discussions about Pilot-Credits EApc66
 Subscribe to new posts about Pilot-Credits EApc66 Post a new question aboutPilot-Credits EApc66
See LEEDuser’s guidance on Pilot-Credits EApc66»

Forum discussion

Pilot-Credits EApc66:Community contaminant prevention - airborne releases

Eapc66 – units of measurement

The emission limits for products of combustion usually use ppm. But the emissions are often measured in other units. It would be good to set up also other emission limits standards or the possibility to use ACP based on local standards for projects outside U.S. to comply with the credit intent.

0
Post a reply

You rely on LEEDuser. Can we rely on you?

LEEDuser is supported by our premium members, not by advertisers.

Go premium for $15.95  »

Profile picture for user petr.lhotak
Petra Hajná
Sustainability Consultant
Skanska Czech Republic
LEEDuser Basic Member
128 thumbs up

Thu, 09/01/2016 - 07:58

There are several comments below on this issue. Would a conversion factor 1ppm of NOx = 1,76 mg of NOx / kWh be acceptable for natural gas boilers? This is recomended in BREEAM International 2013, issue Pol02. For CO emissions I found a conversion factor 1ppm of CO = 1,07 mg of CO/kWh.
Profile picture for user petr.lhotak
Petra Hajná
Sustainability Consultant
Skanska Czech Republic
LEEDuser Basic Member
128 thumbs up

Thu, 09/01/2016 - 08:09

Also I wonder if any gas-fired commercial stoves (e.g. fast-food or restaurant kitchens) would fall under requirements of this credit.
Default Avatar
Kelly Gearhart
Triple Green Building Group, LLC
LEEDuser Basic Member
0 thumbs up

Thu, 02/11/2021 - 23:37

I agree.

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.