See all forum discussions about NC-2009 EAp2

Subscribe to new posts about NC-2009 EAp2 Post a new question aboutNC-2009 EAp2

See LEEDuser’s guidance on NC-2009 EAp2»

FAQs about EAp2 :

Can the Passive House Planning Package (PHPP) be used to energy model for LEED?

Is it acceptable to model a split-type AC with inverter technology compressor as a heat pump, like modeling VRF?

Can the Trace 700 'LEED Energy Performance Summary Report' by uploaded to LEED Online in lieu of the Section 1.4 tables spreadsheet?

A portion of our building envelope is historic. Can we exclude it from our model?

Which baseline HVAC system do I use if my building has no heating or air conditioning?

For an existing building, do I need to rotate the model?

Our project has a diesel backup generator. Should we include it in our energy model?

Our project has a large process load—75%. Despite our efforts to make an efficient HVAC design, the cost savings are minimal. What can we do to earn this prerequisite and be eligible for LEED certification? Is there any flexibility in how we model the p

Can SHGC be higher in the proposed than in the baseline model?

Our process load is higher than 25%. Do we have to justify that?

Do I need to justify the electrical and fuel rates I am using in my model?

Our local code references ASHRAE 90.1-2010. Should I use that for my documentation, or 90.1-2007?

Can I claim exterior lighting savings for canopy lighting even though a baseline model cannot include shading elements?

The project is built on a site with existing exterior lighting installed. How should this be accounted for?

Can mezzanines open to floors below be excluded from the energy model?

How do I provide a zip code for an international location?

For a project outside the U.S., how do I determine the climate zone?

For a project outside the U.S., how do I determine the Target Finder score?

Do hotel rooms need automatic light shut-off control?

How commonly are the 90.1 mandatory compliance forms submitted as part of EAp2/EAc1?

View answers »

Forum discussion

NC-2009 EAp2:Minimum Energy Performance

Old HVAC equipment transferred from other site

Yastimy Jupson

Green Building Consultant

LEEDuser Basic Member

0 thumbs up

August 21, 2014

Hello, I have a new factory project recently. The owner wants to transferred old HVAC equipment from their old factory to this new factory. Do these old HVAC equipment transferred from other site need to meet ASHRAE 90.1 Mandotary Parts? I know the on-site existing HVAC equipment needn't, but not sure about this case. Also, do I need to compare these old HVAC equipment to ASHRAE required baseline system? or I can use old HVAC equipment for both baseline and proposed case? Thanks!

Post a reply

Marcus Sheffer

LEED Fellow

7group / Energy Opportunities

LEEDuser Expert

4454 thumbs up

Tue, 08/26/2014 - 13:30

The old HVAC equipment used in a new facility would need to comply with the mandatory provisions. For LEED the project needs to comply with the ASHRAE 90.1-2007 mandatory provisions. In this case the mandatory provision for equipment efficiency would need to be met.

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.