See all forum discussions about NC-2009 IEQc6.2
 Subscribe to new posts about NC-2009 IEQc6.2 Post a new question aboutNC-2009 IEQc6.2
See LEEDuser’s guidance on NC-2009 IEQc6.2»
FAQs about IEQc6.2 :

I’m working on a project that has transient occupants. How does the IEQ space matrix address transients, and are transients required to have access to the controls?

Do I have to include all individual and multi-occupant spaces and do they have to be consistent across IEQc6.1 and IEQc6.2?

The categories given in the IEQ space matrix don’t really fit how some of the rooms in my project will be used. What should I do?

In some areas, individual fan coil units can be adjusted through the BMS, which can be accomplished by the occupant phoning the building manager. As each unit can be controlled, is this sufficient for occupant controllability? A benefit is that the BMS ca

View answers »

Forum discussion

NC-2009 IEQc6.2:Controllability of Systems—Thermal Comfort

How to reconcile IEQc6.1 and 6.2 Forms for residential spaces?

Default Avatar
Erica Downs
LEED Consultant
The Green Engineer
LEEDuser Basic Member
188 thumbs up

The Space Matrix says for residential spaces, each unit needs one thermostat, and the location does not matter. For lighting, we need at least one switch per room. So how do we reconcile the spaces on the forms? If we list the exact same spaces we have for 6.1 (bedrooms, kitchen, living space) in the 6.2 form, it appears we have an inadequate number of thermostats. Any suggestions? Thanks!

1
Post a reply

You rely on LEEDuser. Can we rely on you?

LEEDuser is supported by our premium members, not by advertisers.

Go premium for $15.95  »

Fri, 09/20/2013 - 14:24

im wondering the exact same thing - but posted under the 6.1 credit. Still waiting on help. I also emailed USGBC with question... if I get an answer i'll share here as well.

Mon, 09/23/2013 - 15:42

Hi Erica and Michael, The current forms do not have residential-specific information. I suggest using the special circumstances section of the form for your project.

Mon, 09/23/2013 - 18:26

thanks, i have a follow up question. on IEQc6.2, i checked "special circumstances" and filled out explanation. but then after saving form, when I hit "check compliance" - it still shows "0". do I just have to submit it with the "0", even though I expect the 1 point?

Mon, 09/23/2013 - 18:28

Hi Michael, exactly, submit the form even though it is showing 0 for points documented.

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.