See all forum discussions about NC-2009 IEQc8.2
 Subscribe to new posts about NC-2009 IEQc8.2 Post a new question aboutNC-2009 IEQc8.2
See LEEDuser’s guidance on NC-2009 IEQc8.2»
FAQs about IEQc8.2 :

Why does the LEED Reference Guide call for vision glazing between 30 and 90 inches, but I have to show compliance at 42 inches?

What is considered a regularly occupied space?

What can I do if my prescriptive method calculation results in a value less than 0.150?

What can I do if my prescriptive method calculation results in a value greater than 0.180?

For Exemplary Performance, what is a View Factor?

Does furniture need to be included in floor plan when completing views calculations?

If views are accessible from a seated position, yet above 42”, can these contribute to the views calculations?

View answers »

Forum discussion

NC-2009 IEQc8.2:Daylight and Views—Views

What are reviewers looking for in the section views

Profile picture for user Marais.Jean
Jean Marais
b.i.g. Bechtold DesignBuilder Expert
LEEDuser Basic Member
581 thumbs up

I have provided plan views where it is assumed that one can't see over the shown case work, etc. I have provided elevations where one can see the height and size of windows. Still it is required to submit sections. I have 12 very different regularly occupied spaces. What are reviewers looking for in the section views? Do I need to beg my architect to provide me with 12 sections?

3
Post a reply

You rely on LEEDuser. Can we rely on you?

LEEDuser is supported by our premium members, not by advertisers.

Go premium for $15.95  »

Fri, 11/11/2011 - 15:33

I would use whatever sections the architects are providing in their drawing set. I haven't had a problem with it yet. Then I draw a line from the top of the window, the bottom of the window and the 42" point on the window back to the furthest part of the section where these lines go without being obstructed to show the views.
Profile picture for user Marais.Jean
Jean Marais
b.i.g. Bechtold DesignBuilder Expert
LEEDuser Basic Member
581 thumbs up

Mon, 11/14/2011 - 08:31

Ha ha, that's my problem. There are and will most probably be no section views. This is an extra ask for a really small project 7141 ft². That is why I need to know which sections are wanted and what is important on them so I can ask for the bare minimum.

Wed, 11/16/2011 - 22:34

Are you trying to show areas that comply where it isn't obvious on the plans and elevations that they do? I think this is the reason they ask for sections. For example, if the lines you have drawn on the plans to show access to a view is drawn through something on the plans and a reviewer might not know how tall that object is, show them in section that it is not over 42" tall. I don't think sections are mandatory if they aren't adding information to the submission.
Profile picture for user davidp
David Posada
Integrated Design & LEED Specialist
SERA Architects
LEEDuser Expert
1361 thumbs up

Mon, 11/21/2011 - 16:49

Jean, This is one of those times where providing a little more information in the submission may save time and trouble later, since a reviewer is very likely to ask for a section drawing. At the very least, you could do a hand drawn section on graph paper that shows the window heights, view angle, and the height of any partitions or obstructions. Just do one that represents a typical condition, and add a note explaining why the construction drawings didn't include sections.

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.