See all forum discussions about NC-2009 EAc4
 Subscribe to new posts about NC-2009 EAc4 Post a new question aboutNC-2009 EAc4
See LEEDuser’s guidance on NC-2009 EAc4»
FAQs about EAc4 :

We plan on pursuing this credit only if we need to do so to meet our certification target, i.e. if another credit we are counting on gets rejected. How late can we apply for this credit?

I'm working on a renovation project and we'll be keeping some of the existing equipment. Shoud we include these systems in our calculations?

Which portions of a VRF/VRV system should be considered for this credit?


For a split system, does the cooling capacity refer to the cooling power of the interior device (evaporator) or of the outdoor unit (condenser)?

What is the required timeline for completing a CFC phase-out for EAc4?

How can I document a longer equipment life (20 or 30 years) than what is listed in the LEED Reference Guide?

Do the requirements apply to portable fire extinguishers or only permanently installed building-wide fire suppression systems?

View answers »

Forum discussion

NC-2009 EAc4:Enhanced Refrigerant Management

Gross ARI rated cooling capacity

Default Avatar
Devani PERERA
Green Building Consultant
Elan
LEEDuser Basic Member
15 thumbs up

Hi, Where should I get the "gross ARI rated cooling capacity" for air to water heat pumps ? This is not covered by ARI 550/590 which usually applies to chillers. On the technical data sheets, I found the "nominal cooling capaciy" following Eurovent standard. Do you think I can use this value ? Thanks Aurélie

5
Post a reply

You rely on LEEDuser. Can we rely on you?

LEEDuser is supported by our premium members, not by advertisers.

Go premium for $15.95  »

Mon, 11/28/2011 - 18:09

I think the nominal cooling capacity is close enough for this calculation.

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.