Forum discussion

CS-2009 EAp2: Minimum Energy Performance

See LEEDuser’s guidance on CS-2009 EAp2 »

Zone adjust in residential project

Project location: Thailand

September 11, 2016

Panupant Phapant

SCG Cement - Building Materials

LEEDuser Basic Member

14 thumbs up

Project location: Thailand

September 11, 2016

We have an apartment building project. In 1 dwelling unit has 1 bedroom 1 living unit and restroom. Do I need to separate between bedroom and living quarter ? Can I grouping it in 1 thermal zone per 1 dwelling unit?
We use eQUEST for simulate this model and it have some limit for zone.
The zone is too much if we separate all of the zone for 29 floors building even we used floor multiply method.
Thank you in advance.

Post a reply

Marcus Sheffer

LEED Fellow
7group / Energy Opportunities

LEEDuser Expert

5912 thumbs up

September 12, 2016 - 9:42 am

See ASHRAE 90.1-2007 Table G3.1-9. You can zone it a couple of ways.

Log in or register to post comments

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.

See all forum discussions about CS-2009 EAp2

Subscribe to new posts about CS-2009 EAp2

Post a new question about CS-2009 EAp2

See LEEDuser’s guidance on CS-2009 EAp2 »

FAQs about EAp2:

Is it acceptable to model a split-type AC with inverter technology compressor as a heat pump, like modeling VRF?

A portion of our building envelope is historic. Can we exclude it from our model?

For an existing building, do I need to rotate the model?

Our project has a large process load—75%. Despite our efforts to make an efficient HVAC design, the cost savings are minimal. What can we do to earn this prerequisite and be eligible for LEED certification? Is there any flexibility in how we model the p

Our process load is higher than 25%. Do we have to justify that?

Our local code references ASHRAE 90.1-2010. Should I use that for my documentation, or 90.1-2007?

Can I claim exterior lighting savings for canopy lighting even though a baseline model cannot include shading elements?

The project is built on a site with existing exterior lighting installed. How should this be accounted for?

Can mezzanines open to floors below be excluded from the energy model?

How do I provide a zip code for an international location?

For a project outside the U.S., how do I determine the climate zone?

For a project outside the U.S., how do I determine the Target Finder score?

Do hotel rooms need automatic light shut-off control?

How commonly are the 90.1 mandatory compliance forms submitted as part of EAp2/EAc1?

The Section 9 space-by-space method does not include residential space types. What should I use?

Can the Passive House Planning Package (PHPP) be used to energy model for LEED?

Can the Trace 700 'LEED Energy Performance Summary Report' by uploaded to LEED Online in lieu of the Section 1.4 tables spreadsheet?

Which baseline HVAC system do I use if my building has no heating or air conditioning?

Our project has a diesel backup generator. Should we include it in our energy model?

Can SHGC be higher in the proposed than in the baseline model?

View answers »