See all forum discussions about NC-2009 WEp1

Subscribe to new posts about NC-2009 WEp1 Post a new question aboutNC-2009 WEp1

See LEEDuser’s guidance on NC-2009 WEp1»

FAQs about WEp1 :

Will the reviewers accept a spreadsheet as a plumbing fixture schedule in lieu of the plans from the Construction Documents?

In LEED review comments I've been referred to the Water Use Reduction Additional Guidance document. I didn't know this was a required reference document.

Should I include bar sinks? What about mop sinks or janitor sinks? Swimming pools? Safety showers? Bidets? Tub spouts?

We provided new showers in our project to comply with the alternative transportation credit. Should they be considered in WEp1 calculations?

Can you explain the 12-second duration for metering faucets?

Can I use a nonpotable water source to contribute to WEp1 compliance?

Our project does not have any eligible water fixtures in the project boundary. Can we comply with WEp1?

We are having trouble finding EPAct-compliant fixtures. Is that a problem?

Where can I find a clear meaning of "public" and "private" as relevant to lavatory faucets?

Our project is a factory with historically a 95% male workforce. The restroom design accounts for this. Can I argue that the male/female gender ratio is different than 50/50?

Are shower duration controls an acceptable water-saving strategy?

Can I include process water savings in order to earn an Exemplary Performance point?

View answers »

Forum discussion

NC-2009 WEp1:Water Use Reduction—20% Reduction

Different GPF for two WC's in same fixture group

Razan Nejem

Environmental Engineer, LEED AP BD+C

LEEDuser Basic Member

38 thumbs up

December 24, 2017

In an office building the the public restrooms have two kinds of Dual Flush WC's with different gpf, one WC has 0.79 gpf and the other one has 0.82 gpf.

In this case, can I make them as average like or choose the fixture with the largest gpf (0.82)?

Post a reply

Gerren Wagner

7Group

LEEDuser Basic Member

16 thumbs up

Wed, 01/03/2018 - 19:54

You could either use the fixture with the largest gpf to be conservative, or you can split the uses between the two fixtures by entering two different lines in the calculator and setting a percentage for usage for each fixture. If you choose to go this route, be sure to provide a description for how the percentages were determined (which occupants are expected to use which fixtures).

Add new comment

To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.