Can the Passive House Planning Package (PHPP) be used to energy model for LEED?
A portion of our building envelope is historic. Can we exclude it from our model?
Which baseline HVAC system do I use if my building has no heating or air conditioning?
For an existing building, do I need to rotate the model?
Our project has a diesel backup generator. Should we include it in our energy model?
Can SHGC be higher in the proposed than in the baseline model?
Our process load is higher than 25%. Do we have to justify that?
Do I need to justify the electrical and fuel rates I am using in my model?
Our local code references ASHRAE 90.1-2010. Should I use that for my documentation, or 90.1-2007?
Can mezzanines open to floors below be excluded from the energy model?
How do I provide a zip code for an international location?
For a project outside the U.S., how do I determine the climate zone?
For a project outside the U.S., how do I determine the Target Finder score?
Do hotel rooms need automatic light shut-off control?
How commonly are the 90.1 mandatory compliance forms submitted as part of EAp2/EAc1?
Forum discussion
NC-2009 EAp2:Minimum Energy Performance
Dear All we have one chillier with a capacity of 1000 Tons. But it is served the Cooling to two building (LEED & Non LEED) one is LEED Building and another one is non LEED scope In this case how we model this chillier in energy simulation for LEED building. these two buildings are not connected and not in same campus these two buildings are disconnected by compound wall
LEEDuser is supported by our premium members, not by advertisers.
To post a comment, you need to register for a LEEDuser Basic membership (free) or login to your existing profile.