Francesco Passerini R2M Solution Srl LEEDuser Basic Member 16 thumbs up May 9, 2017- 9:25 am Sorry, my comment was relative to ASHRAE 90.1-2010. Shall I write the question in the forum relative to LEED v.4?...

We have received our Design Final Review comments and the LEED reviewer has denied EAp2 because the proposed equipment capacities do not match the equipment schedules on the HVAC drawings. Our...

Hi,
Is it required that the Tenants comply in their lighting designs with the Lighting Power Density requirement of ASHRAE 90.1 2007?

Or is it just for energy modeling purposes...

LEED indicates that "Projects outside the U.S. may use an alternative standard to ANSI/ASHRAE/IESNA Standard 90.1‐2007 if it is approved by USGBC as an equivalent standard".

If a office...

Hi, We are working on a core and shell project. While filling minimum energy performance calculator table we met with some issues. In the minimum energy performance calculator table form, there...

Hi,

I would like to ask 3 simple questions:

1) if a humidifier in proposed...

We are working on a retail mall where each tenant retail space is provided with a chilled water tap off. The Supply air CFM, fresh air CFM and cooling capacity tr is already calculated and the...

Hi everybody
I'm working on file "Minimum Energy Performance Calculator" for EAp2 (last version available in Resource on leedonline) which is unlocked.
I need to fill in a new...

Marcus Sheffer LEED Fellow 7group / Energy Opportunities LEEDuser Expert 5867 thumbs up November 28, 2016- 4:25 pm Hi James- There could be any number of reasons for this which is probably why you have not been getting any responses. Your question is too broad and general. Figure out as much as you can on your own and then ask more specific questions and you will likely get responses. It is hard to give someone basic training in a forum for specific questions. Did you get some numbers yet? Log in or register to post comments James Lee Engineer ARC Engineering LEEDuser Basic Member November 28,...

Hi,

We have Core & Shell project while calculating the area of the locations, Pif and EAp2 have difference approximately 4% please let us know what is the maximum percentage deviation...