I have a project where the proposed design has demand controled ventilation. I modeled the...

Does anyone out there know what the following comment pertains to:
Provide additional information (Mech-5C report) to verify that the Proposed Case Carrier units have been modeled at a 50%...

HAP version 4.5 is not capable of modeling hot water temperature supply temperature reset in the baseline case as required under ASHRAE 90.1-2007 Appendix G3.1.3.4 yet the software has been...

Does anyone out there know what the following comment pertains to:
Provide additional information (Mech-5C report) to verify that the Proposed Case Carrier units have been modeled at a 50%...

can be provided in a forum like this and I am not intimately familiar with IES. In eQUEST we would likely just create separate meters for each building within a single model. But that would also depend...

Following requirement is stated even in the LEED 2009 School Alternative compliances path for project outside the U.S.(July 2012)

"The project must establish an energy performance rating...

delete

We have a existing building that is LEED Silver and we are adding to same building. New addition is also LEED Silver. Do I need to model both existing and new addition or only new addition. I...

The baseline U-values proposed by ASHRAE 90.1-2007 for a building with high thermal mass in climate zone 1 (see below extracted from table 5.5-1) seem to be too low-performing. Are these correct...

I'd like to understand better how to input what is needed in Table L-1 for our solar thermal system (our solar PV system was easy to input). The system designers say the annual production is 9.4...