How is a factory applied steel finish addressed in this credit?

The credit language address all sorts of primers and paints, including anti-corrosive paints, but does not address anti-...

I want to appologize if the answer on my question is to obvious but I currently have a language problem:

1. Here "flat" is meant in terms of brilliance / glossy?
2. Where is the...

My project is going for LEED CI 2009 ,, i can't find the...

Tristan Roberts Representative Vermont House of Representatives LEEDuser Expert 11474 thumbs up September 7, 2010- 10:40 am How about "graphic arts coating"? We discussed this on the Schools forum for this credit. Log in or register to post comments Leslie Jones Interior Designer FOX Architects LEEDuser Basic Member 57 thumbs up September 7, 2010- 11:05 am Thanks Tristan. Sounds like I can classify as that and if needed, can create a VOC budget if that classification is not accepted. Log in or register to post comments John Drigot Design/LEED Specialist The Neenan Company LEEDuser...

Are primers classified an non-flat paints in all circumstances? This is confusing because LEED CI 2009 specifies the...

Hello,
Millwork sub would like to use Becker Acroma Ultra Hide Primer (ND52003G) for a project in WDC. The...

I am working on LEED CS for high-rise building.
I have questions about the location that needs to apply Low-...

I have two products that were used on our project. A primer and paint. The cut sheets from Manufacturer state the...

IEQc4.1-4.2 mainly focuses on...

Hello all,

One of our CI project will be using the blinds with Graphic prints. My question is if the ink needs to comply with any of IEQ requirements? Any guidance would be greatly...