The project is totally mechanically ventilated .I am choosing adding CO2 sensors in dense areas for option 2 for additional...

We are trying to figure out the...

Why the indoor water use calculator  excel sheet is protected ?Any clue about the password?

Hi, 

We are working on LEED project as general contractor in middle east which is registered under LEED new construction. 

As a part of compliance with SSP1, we have implemented...

Hello all!

I was able to get the water analysis report from the responsible party, however they don't measure the Silicon oxide parameter, can we still target this credit if all other...

Is my understanding correct that the building roof must be green to satisfy this credit ? The project is an office building with most of the parking underground and a small surrounding paveway...

Hello to All,

Greetings!

I am doing the energy model for Office Building which has located in Basement. In our software, U value only can be given as input.

In this case,...

I would like to know what is LEED's take on developing a site which is on reclaimed land.  The land for the site is not specifically claimed for the project, it has been reclaimed about 15-20...

Is it a must to start a simple box energy model for a new project to extract HVAC requirements to acheive a certain level of energy savings?

Oe is there a guide that can be used to extract...

If a building uses district cooling (CFC-free) but has a backup system (split units) using R-22 refrigerant does the project earn 1 point under Enhanced Refrigerant Management credit? ...