Hello colleagues,
I have a question from our energy modelling team. The question is about baseline HVAC systems modelling.
ASHRAE 90.1, appendix G, point G3.1.1 requires modelling...

Hi Markus,
I'd like to ask you for your opinion and advice about applying these values following the case described below.

In LEED glossary such spaces are determined as 25 people...

Greetings everybody

I'm modeling a datacenter at the moment and there few issues I'm wondering how to proceed.
The project consists of two building adhered to each other. The floor...

Greetings,

In the IEQp1 calculation form, provided by USGBC for using in LEED v4, in the Occupancy Category pull-down menu, there is nothing related to equipment rooms, non-occupied stores...

Greetings everybody

I'm modeling a datacenter and there are few issues about which I'm wondering how to proceed.
The project consists of two building adhered to each other. The floor...

Hello,
We have a project in Russia under LEED for CS-2009 sertification.
There are technical rooms with epoxy flooring.
1) Can anybody confirm if I am wrong or right? Epoxy...

Greetings,
There is an issue on applying F factor about which I'd appreciate some assistance.
The F factor in general refers to the floor slab edge insulation. Its value depends also...

Hello,
We are carrying out LEED certification of an office building. We have an atrium (similar to an indoor courtyard) in our building, which is mainly used as a corridor (passage) between...

Markus, thanks a lot for your answer.
Another issue appeared to this Heating only system - Baseline modeling of...

I'm working on a work center project which is located in Moskov, Russian Federation. I have a problem with area which is described as a regularly occupied area. I use 2009 edition of LEED...