Hi all, We have a project back in climate zone 1 and in the struggling to understand energy modeling for such building combination.

I am working on a project where two buildings directly adjacent to each other but separated by 10-20 feet are being designed to be connected by an underground tunnel.

Hi All, We have a project that has a lot of meeting rooms (area of each room is smaller than 150 square feet) that can accomodate 4 person per meeting room - therefore considered densely occupied

Greetings. I am working on a Commercial interior project pursuing the EAP2, and I chose the section 11 as an alternative to prescriptive approach, but, i am a little bit confused about how to sim

The project in question is a design and build project for which the general contractor will be assigned the project's design and construction activities; however, there is an architectural and engi

We prepared the RFP (or bridging documents) for a design-build project.

Hi LEEDuser community, I have read some old posts regarding this issue, but I still want to double check with you guys. I hope you don´t mind.

Hello all, according to the document “Treatment of District or Campus Thermal Energy in LEED V2 and LEED 2009 – Design & Construction”, for Option1: Virtual District Hot Water Rate [$/MBTU] =

Our project is located in Ithaca, NY and curbside recycling pickup has moved into a single stream recycling collection.

Hi All, I am modeling a 350,000 sqft dormitory/dining hall located in NY. Part of the roof of this building green roof (approximately 10%).