Hi,

The project has male and female restrooms with urinals in the male restrooms, as well as unisex restrooms without urinals in the basement and ground levels.

Initially, I had...

Hello,

Our project is a two floors and 1300 m2 building, opened to four orientations. We have some problems with the unmet hours, because there is no a representative area, where...

We are working on a project with a bus repair...

Tristan Roberts Representative Vermont House of Representatives LEEDuser Expert 11477 thumbs up July 12, 2013- 4:25 pm I would reference the addenda that talks about this. I think we talk about it in our guidance on LEEDuser above and on MRc4.The fabrication point is fine as the manufacturing location, but I agree that the scrap yard is better as the extraction location. This is a bit of a gray area, however, as you have probably noticed from these forum discussions. Log in or register to post comments Tiffany Moore Built Environment Professional Built Kansas City LLC LEEDuser Basic Member 35...

The 200 yard rule applies to bicycle racks outside of the project boundary but how about public showers outside of the project boundary? I am working on a college building and the building next...

Hi there
I think it's pretty obvious this is not going to comply but thought I bring this up for any comments or reconfirmation.

Extraction & Mill [Germany] - Final Manufacturing...

Hi!

I have a project where a fan coil is providing outside air (outside air treated) to other fancoils.

How do I enter this fan coil (outside air) on the worksheet 62MZCalc?

...

Hi!

the only method to check compliance is this?

- Based on Space Floor Area – Both
Interior and Perimeter Spaces

- Limitation on Distance of Interior
Spaces from...

What if.... you have two products being purchased for a project: 1) a zero-...

Our project has less than 1% landscape area vs site area and therefore negligible potable water consumption for irrigation. According to the LEED criteria, this means that 4 credits will be lost...