Log in
Forum » Credit Forums
Topic

Wind Energy Calculation

NC-2009 EAc2: On-Site Renewable Energy
posted by Sonrisa Lucero on Apr 19, 2010, 7:06 pm

I am working on a project that will have two wind turbines. Does anyone know what is a LEED acceptable means for calculating the wind energy (...

Last reply: Shillpa Singh, May 6, 2010, 3:30 pm

Schools SSc4.3

Schools-2009 SSc4.3: Alternative transportation - low-emitting and fuel-efficient vehicles
posted by Anish Shah on Apr 21, 2010, 11:52 am

Has anyone come across any strategies or ways as to how buildings which qualify and get this cerdit go about enforcing, specially in schools.

Last reply: Karen Anderson, May 6, 2010, 1:30 pm

Study on fly ash or slag and SRI value

NC-2009 SSc7.1: Heat island effect - nonroof
posted by Shannon Gray on May 6, 2010, 12:04 pm

There is a good study on the...

IPC or UPC for California?

EBOM-2009 WEp1: Minimum Indoor Plumbing Fixture and Fitting Efficiency
posted by Rachael McClain on May 5, 2010, 6:52 pm

Hi, I was wondering if someone could tell me if the project is based in California do we still use IPC/...

Last reply: Jason Franken, May 6, 2010, 10:08 am

Base line consideration

CI-2009 EAc1.3: Optimize energy performance - HVAC
posted by Pierre Dammous on Apr 30, 2010, 10:24 am

What should we consider as baseline if we are replacing some of the HVAC equipments?

Last reply: Erik Dyrr, May 5, 2010, 6:05 pm

Cleaning Equipment in Multi-family Residential

EBOM-2009 IEQc3.4: Green cleaning - sustainable cleaning equipment
posted by Carey Paul on May 4, 2010, 2:15 pm

We are going for LEED ...

Last reply: Corinna Kester, May 5, 2010, 12:05 pm

metered showers

NC-2009 WEp1: Water Use Reduction
posted by gustavo goldman on May 4, 2010, 5:35 pm

We are looking to incorporate metered showers into one of our buildings. However, the LEED 2009 WEp1 template does not explain how to consider the use of metered faucets. The baseline...

Last reply: Jean Marais, May 5, 2010, 12:24 am

Where is a material "manufactured"

NC-2009 MRc5: Regional Materials
posted by Clint Newton on May 4, 2010, 2:14 pm

We are thinking of using a manufaturer of storefront whose factory falls outside the 500 mile radius of our project, but the fabrication shop that will cut, fit, and preassemble sections is only...

Last reply: Tristan Roberts, May 4, 2010, 2:28 pm

Low-flush WC problems

Schools-2009 WEc2: Innovative Wastewater Technologies
posted by Maya Karkour on May 4, 2010, 10:12 am

Hi all,

I heard that there may be issues with very low-water WCs, such as the 2-4 liters per flush – i.e. in the sense that you would need to flush it twice to get the effect needed.

...

Last reply: Tristan Roberts, May 4, 2010, 12:57 pm

International Project

Schools-2009 RPc1: Regional Priority
posted by Diana Wellenbrink on May 2, 2010, 11:45 pm

Any information when internatinal projects will be able to obtain these points?

Last reply: Tristan Roberts, May 4, 2010, 12:47 pm