Topic | Recent |
---|---|
Definition "individual energy end use"?NC-v4 EAc3: Advanced Energy Meteringposted by Lise Dannesboe on Jan 6, 2017, 5:58 am
Hi, i went though all the comments on this forum and cannot really find a clear answer to the question i have when i read the sentence: "any individual energy end uses that represent 10% or more... Last reply: Marcus Sheffer, Mar 4, 2021, 9:38 am |
|
Particulate Measurements for V4.1NC-v4.1 EQc4: Indoor air quality assessmentposted by Sharon Bessa on Mar 3, 2021, 5:51 pm
I have been advised that the TSI Dust-Trak DRX can now be used for the particulate measurements. Has anyone used this successfully (gained certification)? Is it acceptable to use... |
|
Compliance to Type III PS EPDNC-v4.1 MRc2: Building product disclosure and optimization - environmental product declarationsposted by Melinda Orova on Mar 4, 2021, 8:02 am
Hi everyone! Hope you're doing great. I'd like to ask if the following EPD fulfills the requirement of Type III EPD PS with external verification? Thanks a lot! ... |
|
ASHRAE Standard for Hospitality projectHospitality-NC-v4 EAp2: Minimum Energy Performanceposted by Nikos Tsitsikas on Mar 4, 2021, 7:50 am
Hi all, We are working on a v4 Hospitality project which consists of various single-storey bungalows. Would you please advise on which ASHRAE Standard should be used? Would that be 90.1 or... |
|
Single-zone System (exception 'b' to G3.1.1) dealing withNC-v4 EAc2: Optimize Energy Performanceposted by Ale g on Mar 2, 2021, 8:24 am
How do you deal with exception (b) to G3.1.1? Do you apply a single-zone system (1) to spaces that have a COOLING or HEATING PEAK LOADS that differ more than 31.2 W/m2 to other spaces... Last reply: Ale g, Mar 4, 2021, 3:15 am |
|
baseline ventilation rate for DOAS systemNC-v4 EAp2: Minimum Energy Performanceposted by X. Chen on Mar 3, 2021, 8:30 pm
Hi, we have a DOAS system in the design and our baseline system is Sys#8,... |
|
Interior Lighting Dimming controls in Multi-use spacesNC-v4 EQc6: Interior lightingposted by Summer Gorder on Mar 3, 2021, 5:20 pm
The interior lighting of our projects has 3 zones for dorm rooms, but has dimming with manual on/ automatic off controls. There are also daylight zones. Can the dimming meet the 3 lighting levels... Last reply: Glenn Heinmiller, Mar 3, 2021, 6:54 pm |
|
Elevators in the ProposedNC-v4.1 EAp2: Minimum Energy Performanceposted by Isabel Santos on Feb 26, 2021, 2:59 pm
I am currently computing the elevators' energy consumption in the baseline according to Table G3.1, section 16. After assessing the total peak elevator motor power per car, as Design Builder (... Last reply: Marcus Sheffer, Mar 3, 2021, 10:55 am |
|
Decentralized PM measuring devices permanent installationNC-v4.1 EQc4: Indoor air quality assessmentposted by Sascha Krause on Mar 3, 2021, 9:48 am
Hello all, It's first time that I work with LEED regulations and can't find something about permament installation of PM measuring devices and whether installed devices can improve the... |
|
Construction cost increaseLEED v4.1 Discussion Forumposted by Davide Liviero on Mar 3, 2021, 9:44 am
Hello everyone, I am preparing a preliminary study for a hospital that we are aiming at certifying LEED v4.1 Gold. I have been given the task to predict the variation in terms of cost of... |